![]() ![]() Next step is to remove the one screw holding the gray plastic cover (water channel) that is over the inner edge of the light unit.under it you will find the two mounting nuts remove those and light comes out.unplug connector. ![]() Sorry pics don't copy.but this is the procedure.they show putting something like masking tape along the edge of the cutout in the body to prevent paint scratches as the light is wiggled out after taking the mounting screws off. Make sure gap dimension (outer) is uniform all round between rear light (1) and side wall.Ĭlip in the trim for the water channel (2) at the rear light.Ĭheck trim for water channel (2) is correctly seated. Make sure rear light (1) fits correctly seated in the guides. Join the rear light (1) in the side panel.Installation note: Guide (1) and gasket (2) on rear light (3) must not be damaged or missing.Ĭonnect connector (1) with the rear light. ![]() Pull rear light (1) evenly out of the side panel and the guides. Tape off entire area (1) with yellow plastic adhesive tape.Ĭarefully unclip the trim for the water channel (2) from the rear light. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |